Forums/Version 2/Beta testing support area
IP cameras : AXIS M1114, Panasonic VW SP-105
Oliver Schossmann
asked this on November 30, 2011 13:10
I was able integrate the MJPEG stream of the AXIS M1114 camera ( <IP>/axis-cgi/mjpg/video.cgi?resolution=1280x720&camera=1&compression=25 ).
But as far I can tell, the h.264 stream ( <IP>/axis-media/media.amp ) does not work.
I was not able to get any video signal from the Panasonic VW SP-105. Neither JPEG (of course), nor RTSP ( <IP>/MediaInput/h264 ).
(All streams of both cameras work fine in VLC.)
As I read in a previous post ('IP Camera Motion'), you intend to support motion detection for IP cameras, at least triggered by the device itself. Is there an Interface implemented to receive alarm signals from IP cameras?
But my initial impression of your software is quite poitiv and I am looking forward to further improvements.
Oliver
Comments
Oliver,
In beta 9 we will be adding software motion detection for IP cameras. Depending on how that goes, we may delay adding support for cameras that can send motion detection to our software so we can focus on other issues before 2.0.
You can try adding a ?tcp at the end of the RTSP path in 'Advanced Settings' under the Axis camera (/axis-media/media.amp?tcp). If that still doesn't work, then enable IP camera debugging (IP Camera -> Settings) and then attached that.
As far as the Panasonic goes, it would be great if we can get remote access to that camera to poke it. I don't believe we've had access to that model.
Thanks
Curtis,
I sent an e-mail - using your web-form - to your support-departement how to access the camera.
regards Oliver
Oliver,
Thanks, I'll look at it now